Auto Block
此内容尚不支持你的语言。
The Auto Block module predicts when you are going to take damage and blocks your sword to reduce it.
Mode
Auto Block can be used in two modes.
Legit
This mode tries to predict when you are going to take damage and blocks right before that happens.
Chance
Specifies the chance of Auto Block blocking your sword.
Predict time
Since the timing of blocking heavily depends on your ping, this setting can be used to make Auto Block block earlier to compensate for delays due to lag.
Higher ping will require a higher value for this setting.
Maximum hold time
Controls how long your sword will stay blocked. Higher values mean a higher chance of successfully blocking hits, but you will also lose more speed.
Force block animation
If enabled, your sword will appear blocked the entire time.
Lag
Auto Block can be configured to lag (blink) when your sword unblocks, so you stay blocked for a longer period of time from the server’s perspective. Note that you can use Blatant mode to use even more lag to block almost all hits, at the cost of the module being much more obvious.
Chance
The chance of lagging after unblocking.
Maximum duration
Specifies the maximum lag duration. Higher values will increase the chance of blocking a hit, but may also delay your attacks.
Blatant
This mode keeps your sword blocked at all times (as long as conditionals are met). It will reduce much more damage than Legit mode, but is also a lot more blatant and may flag on some anti-cheats.
Lag duration
Specifies the maximum lag duration. Higher values will allow you to move faster, but will also cause more delayed hits (and potentially higher risk of flagging).
Maximum hurt time
By lowering this value below the default of 500 ms
, Auto Block will temporarily stop blocking after you take
damage. Since you are generally temporarily invulnerable after being hit, this setting can be used to avoid blocking
more than necessary, which allows you to move faster and potentially reduce more knockback by landing more hits on
target.
Conditionals
Auto Block can be configured to only activate if:
- Left mouse button is pressed
- Right mouse button is pressed
- You recently attacked a player (if disabled, Auto Block will keep blockhitting even if you are getting combo’d)
- Aiming on target